Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating and safety precautions
GB
Step 5:
Attaching the upper
tow bar part
Step 6:
Attaching the
safety hood
Step 7
Attaching the trailer
coupling to the bicycle
Step 7.1.
Assembly of the coupling
part to the trailer
Attach the upper tow bar part (part no. 4) to the
lower part and connect the two parts by putting
the screw M6x35 (part no. 9) into the square aperture
and tightening it with the washer (part no. 13) and the
cap nut (part no. 14).
Put both halves of the hood (part no. 19) together
using the connector and then push it into the
aperture provided for this on the rear of the trailer.
Secure the saddle-support mounting, with the help of
the plastic shims, to the saddle pillar of your bicycle.
[Part-Nr. 17]
Now use the screw that is ready-fitted to the saddle
support mounting to attach the ball-head coupling to
the saddle support mounting.
Use 2pcs. Screws M6x35 (part no. 9) as well as
2pcs. washers (part no. 13) and 2pcs. cap nuts (part
no. 14) for assembling the coupling part to the upper
part of the tow bar.
Werbung
