Smart Touch Control; Connecting To The Tv - Samsung Evolution Kit SEK-1000 Bedienungsanleitung

Smart Touch Control

Inserting the Batteries (AAA X 2)
1. Slightly lift the battery cover by pulling the strap or by
inserting a plastic card (e.g. a credit card) into the notch
on the side of the control and twisting. Once the cover is
loose, hold the body of the control firmly with one hand
and pull up on the cover with the other.
2. Insert 2 AAA batteries, making sure to align the positive
and negative ends correctly.
3. Align the battery cover with the back of the remote control, and then press down along the edges until it is completely attached to
the remote control.

Connecting to the TV

To operate the TV using a Smart Touch Control, you must first pair it to the TV via Bluetooth. Note that the Smart Touch Control will only
work with the paired Samsung TV. To pair the TV and the Smart Touch Control for the first time, follow these steps:
1. When the TV is off, move within a few feet of the TV, point the Smart Touch Control at the remote control receiver of the TV, and then
press the TV button.
The remote control receiver's location may vary depending on the model.
✎
The TV button transmits an IR signal only.
✎
2. A Bluetooth icon will appear at the bottom left of the screen as
show side. The TV will then attempt to connect to the Smart Touch
Control automatically.
3. When pairing is successful, the TV displays a small green circle between graphics representing the TV and the Smart Touch Control.
If the Smart Touch Control does not pair, remove the Smart Touch Control's battery cover, aim the Smart Touch Control at the TV's
remote control receiver, and then use a pen tip to press and release the pairing button on the back of the Smart Touch Control. In a
few seconds, you should see the Bluetooth icon described in Step 2, and then the Smart Touch Control should pair.
1
or
English-6
2 3