Carbest CI1000 Bedienungsanleitung Seite 69

GB
Ignition coil
Ignition coil
DC wire
High voltage wire
High voltage wire DC wire
Spark plug
Spark plug
Fig. 5.11 Fig. 5.12
5. Visually inspect the spark plug. Clean the spark plug with a brush if it is to be reused.
6. Measure the plug gap with a feeler gauge. The gap should be 0.7 to 0.8mm (0.028 to 0.031 inch). Correct
as necessary by carefully bending the side electrode (Refer to Fig. 5.13).
0,7 – 0,8 mm
Side electrode
Fig. 5.13
7. Install the correctly gapped spark plug back into the original position.
8. Reinstall the ignition coil securely.
9. Close the top maintenance cover and tighten the screw.
69