Before You Start The Device - Silvercrest SEK 600 A1 Bedienungs- Und Sicherheitshinweise

Do not allow children to
Q
change batteries without adult
supervision.
Always choose the right size and
Q
type of battery for the intended
use. The information provided
with the device for selecting the
right battery should be retained
for future reference.
Clean the battery contacts and
Q
also those of the equipment before
installing the battery.
Remove used batteries imme-
Q
diately.
Do not disassemble batteries.
Q
If the battery compartment does
Q
not close securely, do not use the
remote control and keep it out of
the reach of children.
Avoid extreme conditions and
Q
temperatures that may affect
batteries/rechargeable batteries,
e.g. radiators/direct sunlight.
24 GB/IE

Before you start the device


REMOTE CONTROL:
HOW TO INSERT OR CHANGE THE BATTERY
The remote control unit is delivered together with a li-
thium button cell. To enable the remote control, remove
the plastic tape that protrudes from the battery compart-
ment (see Figure 1).
6
1
If the remote control battery needs to be replaced, in-
sert a new 3-volt lithium button cell. Pay attention to the
type of lithium button cell (CR2025).
2
Press the tab on the battery compartment
5
of the remote control toward the centre. Now pull
out the battery compartment
Remove the old battery.
Insert a new 3V-button-cell battery (type CR2025).
Pay attention to the correct polarity.
Push the battery compartment
mote control unit until the tab
6
(see Figure 2).
6
back into the re-
6
snaps into place.
5