Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Information - simalube IMPULSE Anwenderhinweis

Vorschau ausblenden Andere Handbücher für IMPULSE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
EN

1. Safety information

Compliance with the information contained in this user manual is a prerequisite
for smooth, safe operation. The user manual for the simalube lubricator forms
a part of this document. The operator must guarantee that only qualified staff
work with the lubrication system, that the user manual and necessary safety and
maintenance instructions are observed and that the IMPULSE lubrication system is
used correctly and for its intended purpose. Flawless functioning of the lubrication
system is only ensured through the use of the recommended lubricants, the original
simalube range of accessories and if the assembly and operating instructions are
observed. In the event of non-compliance with these instructions, the manufacturer
accepts no liability whatsoever for any consequential damage or loss. Recycle the
batteries; do not reuse, charge, open or throw them in a fire.
The simalube IMPULSE lubrication system is a state-of-the-art system upon delivery
and is considered inherently safe to operate.
Danger
The lubrication system is pressurised during operation. Prior to disassembly or
maintenance work, all lines and the simalube lubricator must be depressurised.
The lubricator can be depressurised safely by loosening the simalube's gas
generator.
Only use new, originally packed battery packs. Do not open the packaging of the
battery pack until immediately before inserting it into the device. Correct lubrica-
tion is not possible with used or empty battery packs.
Warning
Never remove a pressurised simalube lubricator before it is empty. Otherwise
the gas pressure in the simalube could cause the uncontrolled discharge of
any remaining grease/oil from the lubricator and the battery compartment will
get dirty.
Make sure that the installation can withstand the maximum system pressure.
When priming the IMPULSE, the pressure must never be higher than 2 bar.
The IMPULSE must only be operated in conjunction with simalube lubricators.
Do not expose the installation to direct sunlight.
The IMPULSE must not be cleaned with a pressure washer or steam cleaner.
12
IMPULSE

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis