Maintenance; Cleaning The Thermal Imaging Camera; Inspecting The Thermal Imaging Camera - Dräger UCF 6000 Gebrauchsanweisung

Maintenance

Fault Possible cause
The charger LEDs in- The camera base is
dicate an error during not positioned cor-
the charging process rectly.
or do not light up at all.
No power is being
supplied.
Camera is completely Software malfunction. Press the ON/OFF
non-functional (e. g.:
frozen image, the
camera does not re-
spond to pressed
keys).
38
6
Remedy
6.1
The camera base is
not sufficiently fas-
Display, IR window, and laser window are made from scratch-resistant
tened in place. Re-
material. Carefully clean these surfaces.
tighten screw.
Check and correct po-
!
sition of the shoulder
strap.
Remove foreign ob-
jects from under the
1. Wipe the thermal imaging camera with a damp, lint-free cloth. If
camera base or in the
charger.
2. Dry the thermal imaging camera with a soft, lint-free cloth, and
Place charger on level
3. If moisture has ingressed into the battery compartment, leave the
surface.
Check the function of
6.2
the power supply or
12-30 V connection
cable. 6.2.1
key for 10 seconds
and switch camera
back on again.
Clean the camera if it is dirty. In case of damage, stop using the ther-
mal imaging camera immediately, and have it repaired by trained and
qualified service personnel.
Maintenance

Cleaning the thermal imaging camera

CAUTION
Do not use solvents or diluting agents for cleaning the thermal
imaging camera. Otherwise the camera housing could get
damaged.
necessary, clean with warm soapy water.
leave to dry completely.
thermal imaging camera to dry until the contacts are moisture-free.

Inspecting the thermal imaging camera

Inspections after Use
Check the thermal imaging camera for structural damage and
damage due to heat and chemicals.
Check the display, IR window and laser window for mechanical
damage or dirt.
Dräger UCF 6000/7000