Assembly; Handle Assembly - Greencut GGT1200C Betriebsanleitung

48

ASSEMBLY

ATTENTION: Do not connect the machine to the power supply until assembly is complete. Failure
to comply could result in serious injury.
ASSEMBLY OF THE BARS
1. Loosen the axle connecting knob (8) and remove the upper and lower bar protectors (a, b).
2. Connect the top bar (9) and bottom bar (5) through the shaft connector in the correct direction until it locks.
3. Tighten the axle connector knob.

HANDLE ASSEMBLY

1. Connect the (7) handle to the top bar (5) with the two screws, washers
and nuts and fix them with an Allen key (15).
MOUNTING OF THE HEAD PROTECTION
1. Mount the protector with 3 screws and the Allen key (16).
1