Kemar KSM-1000 Gebrauchsanleitung Seite 34

IMPORTANT SAFETY INSTRUCTIONS
30. Do not operate the hand blender with a damaged cord or plug. If the supply cord is damaged,
it must be replaced by the manufacturer, its service agent in order to avoid a hazard.
31. Blades are sharp. Take extreme care when removing the attachment and cleaning it to avoid
injury.
32. Keep hands and utensils out of container while blending to reduce the risk of severe injury to
persons or damage to the hand blender. After the blade attachment has been removed from the
motor base and the blades have come to a standstill, you can continue working on the contents.
33. Do not operate with loose or damaged blades. Do not remove blade assembly from the
container. Contact your authorized KeMar service representative for service or replacement.
34. When making nut butters or oil-based foods, do not process for more than one minute after
the mixture starts to circulate in the container. Processing for longer periods can cause damage to
the container and motor overheating.
35. To avoid a hazard, this device must not be connected to an external switch, e.g. a timer, or to
a circuit that is regularly switched on and off.
POWER CORD ADVICE
A) The power cord is short in order to avoid entanglement or tripping.
B) An extension cord can be added if used properly.
C) If extension cord is used:
(1) Its power capacity must at least be the same as that of the device's power consumption.
(2) The extension cord must not hang over the edge of the device. Ensure that children cannot pull it
and that the risk of tripping is low.
34
WARNING
Risk of electric shock!
Only use earthed electrical outlets!
Do not remove any of the earth wires!
Do not use an electrical adaptor!
If these instructions are not followed, there is a risk of
fatal injury, fire or electric shock!
EN
KSM-1000