SETUP
Installation
Setup the device on a plane surface or fasten it to a truss or similar rigging structure using the optional holder
(item no. 51786552). Observe sufficient load-bearing capacity and connect an appropriate safety feature in case of
overhead installation.
Caution! Observe all safety instructions on page 16.
Rack installation
The device can be mounted in a 19" rack with the optional mounting blade (item no. 70064874). Use four screws
to fasten the mounting blade to the top and bottom of the housing.
Connection to the power supply
Connect the power adapter provided to the corresponding input on the node and to a mains socket. Thus the
device is powered on. To switch off the device and after the operation, disconnect the mains plug of the power
adapter from the socket, to prevent unnecessary power consumption.
Network connection
Connect the device via one of its two Ethernet ports to your PC or switch. If you are using more than one device
you can daisy chain them through the other Ethernet port or connect them star-shaped to an Ethernet switch. Use
normal patch cables with RJ45 plugs and TIA-568A/B assignment. The opposing side should support at least
100BASE-TX, better 1000BASE-T. For the connection between two nodes no crossover cable is needed.
DMX connection
Connect your DMX512 devices to the DMX outputs.
LED stripe/pixel connection
Connect your digital LEDs to the terminals GND, LED DATA and if available to LED CLOCK.
LED power supply connection
Connect your LED power supply according to its manufacturer's instructions.
Applications
17 • EN