Important Safety Instructions - EuroLite dxt Serie Bedienungsanleitung

CAUTION!
Operating conditions
This device has been designed for indoor
use only. Keep this device away from rain
and moisture.
DANGER!
Electric shock caused by short-circuit
Be careful with your operations. With a
dangerous voltage you can suffer a
dangerous electric shock when touching
the wires!
• Please read these operating instructions carefully
before using the product. They contain important
information for the correct use of your product.
Please keep them for future reference.
• Only use the product according to the instructions
given herein. Damages due to failure to follow
these operating instructions will void the warranty!
We do not assume any liability for any resulting
damage.
• We do not assume any liability for material and
personal damage caused by improper use or non-
compliance with the safety instructions. In such
cases, the warranty/guarantee will be null and void.
• Unauthorized rebuilds or modifications of the
product are not permitted for reasons of safety and
render the warranty invalid.
• Never open any part of the product to prevent a
possible electric shock.
• IMPORTANT: This product is not an outdoor
product! Only for indoor use! Do not use this
device near water. The recommended temperature
range is -5 to +45 °C.
• To clean the unit, disconnect it from the power
source.
• Only use a soft cloth, never use any solvent.
• Do not touch the power cord and connectors with
wet hands as it may cause electric shock.
• This product is not a toy. Keep it out of the reach of
children and pets. Do not leave packaging material
lying around carelessly.
• This unit corresponds to all required directives of
the EU and is therefore marked with
Intended use
The device is designed for distributing DMX512
control signals in lighting installations.

IMPORTANT SAFETY INSTRUCTIONS

.
15 • EN
Overhead installation
WARNING!
Risk of injury caused by falling objects
Devices in overhead installations may
cause severe injuries when crashing
down. Make sure that the device is
installed securely and cannot fall down.
The installation must be carried out by a
specialist who is familiar with the hazards
and the relevant regulations.
• The device may be fastened to a truss or similar
rigging structure via omega clamp. The device
must never be fixed swinging freely in the room.
• Make sure that the product is set up or installed
safely and expertly and prevented from falling
down. Comply with the standards and rules that
apply in your country.
• For commercial use the country-specific accident
prevention regulations of the government safety
organization for electrical
complied with at all times.
• If you lack the qualification, do not attempt the
installation yourself, but instead use a professional
installer. Improper installation can result in bodily
injury and or damage to property.
• The manufacturer cannot be made liable for
damages caused by incorrect installations or
insufficient safety precautions.
• The rigging structure must support at least 10
times the weight of all fixtures to be installed on it.
• Block access below the work area and work from a
stable platform when installing the device.
• Use rigging hardware that is compatible with the
structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section
for a list of suitable rigging hardware.
• Secure the device with a secondary attachment.
This secondary safety
sufficiently dimensioned in accordance with the
latest industrial safety regulations and constructed
in a way that no part of the installation can fall
down if the main attachment fails.
• After installation, the device requires inspections
periodically to prevent the possibility of corrosion,
deformation and looseness.
facilities must be
attachment must be