Sonik Gizmo Bedienungsanleitung Seite 4

SYNCHRONISATION
Please note that your alarms should come pre-registered to the receiver. However, if
you would like to change the registration order or add an alarm to the receiver; follow
the steps below.
1. Press and hold the S-button for 2-seconds until the first channel LED
illuminates.
2. Press again the S-button cycle through the four channel positions. (Bright LED
= channel free, Low LED = Channel in use) To sync an alarm head the channel
must be free. (see step 3 below otherwise move to step 4).
3. To erase a synced channel press and hold the S-button, the channel LED
changes from low to high brightness. To quickly erase all channels, Press and
hold the S-button for a further 5 seconds until all LED's flash brightly 5-times.
4. When the chosen channel is selected and free, activate the required alarm
head by rotating the roller wheel. The receiver will beep; indicating the pairing
is complete.
5. Repeat steps 3 and 4 to sync other alarm heads to the receiver.
6. Turn the receiver off/on or wait for 5 seconds for the receiver to return to
normal function.
FUNCTIONS IN USE
When activated the GIZMO® receiver will replicate the alarm speaker activation and
tone. The channel LED activated will remain latched for 20 seconds. When drop back
indication is detected the white Drop back LED will illuminate and a lower speaker
tone will sound. The receiver will remember its channel, volume and mode setting
even if the battery is disconnected or removed.
ANTI-THEFT WARNING
If the receiver detects that an alarm head has been turned off, the affected channel
LED's and an audible alarm and will sound on the receiver. This alarm can be de-acti-
vated by briefly pressing the V-button.