Torch Function - Sonik Gizmo Bedienungsanleitung

Getting Started
Battery Fitting/Replacement
Remove the battery compartment cover by sliding it carefully down to remove it from
the casing. Insert 2 x AAA 1.5V batteries noting the polarity shown on the connection
terminals. Receiver speaker will sound when batteries are fitted correctly. Replace
the battery cover ensuring that it closes positively into place.
Switching On / Off
To turn the receiver on, press and hold the V-Button; LED's will illuminate in sequence.
To turn the receiver off, press and hold the V-Button; LED's will flash and speaker
sounds.
Volume Control
To adjust volume, press the V button to cycle through the 7 volume levels available.
The lowest volume setting is silent.
MODE SELECTION
To select the receiver mode, press the T-button to cycle through the three following
receiver modes; mode selection will confirm after 2-seconds.
1) Light + Sound
2) Light + Sound + Vibration
3) Light + Vibration

TORCH FUNCTION

To enter torch mode press and hold the T-button for 2-seconds to enable or disable
the torch function.
LAST MEMORY RECALL
Press the M-button and the receiver will indicate the last recorded alert received from
an alarm transmitter.