Polisher Safety Warnings - Status PA125CE Originalbetriebsanleitung

POLISHER SAFETY WARNINGS

POLISHER SAFETY WARNINGS
• This power tool is intended to function as a polisher or machine for cleaning surfaces
with a wire brush. Read all safety warnings, instructions, illustrations and specifcations
provided with this power tool. Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
• Operations such as grinding or cutting-off are not recommended to be performed
with this power tool. This power tool is not recommended for polishing. Operations for
which the power tool was not designed may create a hazard and cause personal injury.
• Do not use accessories which are not specifcally designed and recommended by the
tool manufacturer. Just because the accessory can be attached to your power tool, it
does not assure safe operation.
- Never mount circular blades or grinding wheels for angle grinders.
- Use only accessories appropriate for the processed material and the rotation speed.
• The rated speed of the accessory must be at least equal to the maximum speed marked
on the power tool. Accessories running faster than their rated speed can break and fly
apart.
• The outside diameter and the thickness of your accessory must be within the capacity
rating of your power tool. Incorrectly sized accessories cannot be adequately guarded
or controlled.
• The arbour size of flanges, backing pads or any other accessory must properly fit
the spindle of the power tool. Accessories with arbour holes that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively and
may cause loss of control.
• Do not use a damaged accessory. Before each use inspect the accessory such as
backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires. If
power tool or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and run the power tool at
maximum no load speed for one minute. Damaged accessories will normally break
apart during this test time.
• Wear personal protective equipment. Depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or workpiece fragments.
The eye protection must be capable of stopping flying debris generated by various
operations. The dust mask or respirator must be capable of filtrating particles
generated by your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
• Keep bystanders a safe distance away from work area. Anyone entering the work area
must wear personal protective equipment. Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate area of operation.
5
EN