Emptying The Collection Bag; Overload Protection; Restart Prevention; Working Methods - Deltafox DG-EKS 2445 Originalbetriebsanleitung

GB
Place your chopping material in the fill
hopper. The material is drawn in and
chopped.
2. To switch off, press the "O" button on
the on/off switch (8).
The shredder will continue to run im-
mediately after switching off.

Emptying the collection bag

Avoid filling the collection bag too
much. Mind that the bag will une-
venly fill under the discharge duct!
1. Turn off the unit.
2. Remove and empty the collection bag
(4).

Overload protection

In the event of overload, e.g. due to
branches that are too thick, the equipment
automatically switches off.
To restart, allow the device to cool down
and press the overload protection button
(9). You can then switch on the device as
usual.

Restart prevention

The unit will not automatically restart
when the power returns after a power cut.
To start, now press the on/off switch (6),
button "I".

Working methods

General working instructions

Keep enough distance to the
shredder since long branches
can be spun off while being
drawn into the shredder.
26
Wear ear and eye protection.
Wear hand protection
• When feeding branches to the unit,
keep holding them until they are auto-
matically drawn in.
• Adapt to the speed of the shredder
and avoid overloading the unit.
• To avoid the unit clogging up, mix the
branches with twigs and gardening
waste allowed to wither for several
days.
• To prevent the blades from becoming
blunt quickly, remove mud and stones
from the roots before shredding.
• Do not shred but directly compost all
soft and wet material such as kitchen
waste.
• Keep a couple of dry branches to use
them for cleaning the unit at the end.
• Do not turn off the unit until all the ma-
terial has passed the blades. Remain-
ing material may otherwise block the
blade when you restart the unit.

Freeing up a jam

Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the
blade stands still. There is a risk of
injury and a risk to life from electric
shock, fire and rotating blades.
• Check that the power plug (
pulled properly.
• Unlock the housing interlock (10).
• Tip forward the front part of the shred-
der housing.
• Undo the 8 mounting screws (22) on
the cover plate (23) of the shredding
machine. You can now remove these
and place them aside.
7) is