Maintenance - Aura Elite Classic Controller & Tan Plus Bedienungsanleitung

GB
Assembly
1) Slide the nozzle seal (Fig. 12, 1) with the
groove (slot) facing forwards into the
nozzle (2).
2) Put the nozzle onto the gun body and find
the correct position by turning it.
3) Put the air cap onto the nozzle and tighten
it using the union nut.
4) Place the container seal (Fig. 13, 1) from
below on the feed tube(2) and slide it over
the collar, while turning the container seal
slightly.
5) Insert the feed tube with container seal
in the gun body.

14. Maintenance

Important! Never operate the system
without the air filter; dirt could
be sucked in and interfere with
the function of the system.
1) Change the air filter if it is soiled
(check daily in the case of intensive/
commercial use).
2) Open the cover of the air filter
compartment (Fig. 14).
3) Insert a new air filter into the compartment.
4) Close the cover of the air filter
compartment.
In order to mount the gun more easily
apply lubricating grease (enclosed)
liberally to the O-ring at the spray
attachment (Fig. 15, 1).
8
Elite Click & Tan Plus Sprayer
12
13
2
1
14
15
1
2
1