Electrical Connection; Assembling The Power Plug (Optional) - WITA UPH 15 Original Einbau- Und Betriebsanleitung

9 Electrical connection

Warning: Risk of death!
Incorrect installation and electrical connection can pose a fatal risk.
Prevent hazards arising from electrical energy.
- Only have installation and electrical connection performed by a
specialist and in line with the valid regulations
(e.g. IEC, VDE, etc.)!
- The current type and voltage must correspond with the
information on the type plate.
- Observe the specifications of local energy supplier!
- Observe accident prevention regulations!
- Never pull on the power cable
- Do not bend the cable
- Do not place any objects on the cable
- When using the pump in systems at temperatures over 90 °C, use a
connection line that is suitably heat resistant.
- Hazards such as sharp edges and burrs arise during installation.
- When transporting the pump, never hold it by the power cable.
- The pump could cause an injury if it falls.
9.1 Assembling the power plug
(optional
)
Connect the power cable to the pump as shown.
Caution: Line voltage! Observe the required protective
measures, national body regulations and local provisions
at all times. The cable cross-section may no smaller than
0.75 mm². Use ferrules if using fine-wire cables.
All manuals and user guides at all-guides.com
24