ELRO K1 Bedienungsanleitung Seite 4

3. Connect the K1 Connector to the app
Once you have logged into the app, you
are taken to the network configuration.
Plug in the K1 connector into a power
outlet and wait for the LED indicator to
turn green.
Next, press the K1 Connector's button (1)
for at least 3 seconds until the LED
flashes blue. (2) Press 'Next'.
In the next screen, type in your Wi-Fi
network password (3) and press
'Configure'. The connector will now
connect with your Wi-Fi network. This
will take approximately 1 minute. You'll
be informed whether the connection was
successful or not.
Make sure that you use a 2.4GHz Wi-Fi
signal. This means that this cannot be a
Wi-Fi signal that exists of both 2.4GHz
and 5GHz signals. We recommend that
you turn of the 5GHz signal when
installing the K1. After the installation
you can turn this signal back on again.
-4-