PeakTech 5145 Bedienungsanleitung Seite 31

All manuals and user guides at all-guides.com
5.6. Parameters Setting
1. If duct is rectangle, the height of duct numbers and "H="will be first shown in the primary show.
2. Press
point.
3. Press
Press from
0 to 9.
4. Press button, the width of duct numbers and "W="will be
shown in the primary show.
5. Press
6. Press
7. Press
8. If duct is circular, the diameter of duct numbers and "D="will be
shown in the primary show then select the duct diameter that
you want to use in the same way.
or button to select the decimal
to change the station of flashing digit and
or to change the flashing digit
P/V/F
button to select the next digit.
to change the station of flashing digit and press
or to change the flashing digit from 0 to 9.
to store the new parameters in memory.
-30-