Mounting And Dimensions; Cleaning And Maintenance; Aluminum Filter - Monsher Inlight 55 Bedienungsanleitung

16
SECTION 2.

Mounting and dimensions

Please unpack and inspect the appli-
ance! Before starting installation, make
sure that the hood has no obvious transport
damages. If such defects are detected, do
not install or connect the appliance to the
mains.
INLIGHT 55
min
65 сm
Electric
min
75 сm
Gaz
Fig.1
SECTION 3.

Cleaning and maintenance

Caution! Before you start cleaning the
appliance, disconnect it from the power
supply.

Aluminum filter

Aluminum filter is designed to trap grease
particles out of the flow of air running through
it. For this reason, the filter needs regular
cleaning. The cleaning interval depends on the
frequency of use of the air cleaner. Generally,
it is recommended to clean it once a month.
To do this, remove the filters, wash them
in water with a neutral liquid detergent, dry
them, then set them back in the air cleaner.
Over time, filters may change color due to
a regular washing. This is a natural process,
which does not indicate a defect, so filter
replacement is not required.
The aluminum filters can be washed in
the dishwasher.
How to remove aluminum filters:
1. Press on the latch of the filter lock.
2. Pulling down a bit, remove the filter.
In order to put the filters in place after
cleaning, follow the above instructions in
reverse order.
Carbon filter (used in recirculated
air mode)
Carbon filter is designed to trap odors
and fumes while cooking. It is used in cases
where there is no possibility to connect the
air cleaner to a special ventilation duct for
discharging air outward. When operating the
Русский English