Constant Weighing Data (Theoretical Calibration) - Gicam WIN11 Installations- Und Bedienungsanleitung

Constant weighting data (theoretical calibration)
 +
3 sec.
Const
CALibr
CAPAc
SEnSit
tArE
dSPDVS
Capacity of the weighing system
CAPAc
Set the value corresponding to the sum of the nominal capacities of the load cells, in
kg. This data constitutes the full scale value of the weighing system. Values between 1
and 500,000 kg are accepted. Following the modification of the maximum capacity
value, the theoretical weight calibration is performed.
Sensitivity of the load cells
SEnSit
Set the value corresponding to the average of the sensitivities to the nominal capacity
of the load cells, in mV / V. Values between 0.5 and 4 mV / V are accepted. If no value
is programmed, 2mV / V is assumed. After changing the sensitivity value, the theoreti-
cal weight calibration is performed.
Fixed weighing system tare
tArE
Set the value corresponding to the weight of the tare weight on the load cells. Values
between 0 and the capacity of the system are accepted. Following the modification of
the fixed tare value, the theoretical zero calibration is performed.
Divisions value
DSPDVS
The division value is expressed in kg, selectable between 0.0001 kg and 100 kg.
The ratio between the maximum capacity of the system and the division value consti-
tutes the resolution of the system (number of divisions). Following the modification of
the system capacity value, a division value is automatically selected at the best of the
10,000 divisions. The number of divisions of the maximum capacity (resolution), e. g.
the capacity / division value, must be between 500 and 600,000.
Following the change of the division value, if the maximum capacity is not changed,
the weight calibration is automatically corrected.
Set password
PArAM In out SEriAl
Set value
Set value
Set value
0.0001 100
Pagina – page –
AnALoG oPTion
Seite 67
Exit menu