General Information - Ebode EM Bedienungsanleitung

Transmitter - Wall-Mounted Remote Control
Important: When fitting the switch, always make sure the ebode
logo is situated at the right bottom.
Set the address, if necessary
The X10 address consists of a House Code and Unit Code.
This unique address makes it possible to control one or more receivers
(with the same address) with commands from EM switch.

General Information:

1. The factory default address is set to A1.
This means you can remotely control the X10 compatible receivers which is set
to address A1:
(a) Like e.g. the ebode receivers RMA, RMV, RPT, RPA, RPL (RPA and
RPL require a RF transceiver in order to convert the RF signals to
X10 powerline commands, e.g the RPT).
(b) Or Classic X10 Receivers with rotary address selectors, e.g TM13 or
SC28 security console, when set to the same House code, A.
2. The front LED of the EM module indicates the following state:
- Green: ON
- Red: OFF
Programming the EM switch
Information:
The front LED indicates the 3 following states:
A. Simultaneously press the On and Off button during 1 second
(the LED turns Yellow) then release.
The LED will blink Red for House Code then Green for Unit Code
(the factory setting is A1: One Red blink and one Green blink),
then go to Yellow (program mode).
Go to the next step to configure the House Code and Unit Code.
After 6 seconds the modules will return to normal operation and
leave the program mode.
Start
B. Configuring the House Code
Press and release the ON key the appropriate number of times for
the House Code you want to set. Once for A, twice for B, etc.
The factory setting will be "A = 1 Red Blink"
July 2009
Red LED: House code (A to P)
Green LED: Unit code (1 to 16)
Yellow LED: status of the program mode.
page 6
Ref : EM
EM