Installation - Ebode EMML Bedienungsanleitung

Transmitter - Micro Remote Control Module
INTRODUCTION
The wireless Micro Transmitter allows you to add a switch for extra
incandescent, halogen, low-voltage, energy saving and LED light
fixtures.
• Wireless and inconspicuous, the Micro Transmitter conceals itself behind a switch
of your choosing..
• It integrates with existing switches eliminating the need of pulling wires or
cutting extra holes in the wall.
• It installs in just minutes.
• It's compatible with all ebode radio home automation devices. Visit the site
www.ebodeelectronics.eu
DESCRIPTION
LED indicator
(1) For switching on/programming
(0) For switching off/programming

INSTALLATION

July 2009
1. Cut out a 65 mm hole 40 mm deep with a hole saw.
2. Set the insert box in the wall.
3. Remove the battery's protective tab then press the buttons
to test. Pressing the (0) lights the red panel light. Pressing the
(1) lights the green panel light.
4. Connect the Micro Transmitter's wires to the switch (see
opposite diagram)
5. Place the Micro Transmitter and the switch in the insert box
taking care to pull out the antenna as much as you can.
6. Verify proper On/Off switch operation.
page 6
Ref : EMML
EMML