Troubleshooting - Ebode EMML Bedienungsanleitung

Transmitter - Micro Remote Control Module
PROGRAMMING
In order to add the Micro Transmitter to a different installation from
the original one, or to one with interference from a nearby system,
it is necessary to program a different code.
The programming address is made up of a "HOUSE" code (from A through P) and
a "UNIT" code (from 1 through 16). The factory default address of the transmitter/
receiver pair is set at A1; proceed as follows to set a different code.
A. Accessing programming mode.
- Press the Micro Transmitter's START (1) and STOP (0) buttons briefly and
simultaneously. The LED turns YELLOW.
Then the LED lights up RED once (for the HOUSE CODE), then GREEN once (for
the UNIT code). The Micro Transmitter is in the A-1 setting.
You have 6 seconds to program a new code.
B. Setting the HOUSE CODE.
- Press the (1) button as many times as needed to get to the desired HOUSE
CODE and then release it.
Example: A = Press once, B = Press twice, C = Press three times, ... P = Press
16 times.
- After having set the HOUSE CODE, the LED will flash YELLOW 3 times to confirm
the code has been memorized and exit from programming mode.
C. Set the UNIT CODE.
- Repeat step A only.
- Press and release the (0) button as many times as needed to get to the desired
UNIT CODE and then release it.
Example: 1 = Press once, 2 = Press twice, 3 = Press 3 times... 16 = Press 16
times.
- After having set the UNIT code, the LED will flash YELLOW 3 times.
VERIFICATION
Let the Micro Transmitter be recognized by the receivers.
Verify On/Off switch operation.
You must wait about a second between each On / Off command.
When changing the battery, the registered code will be retained by the Micro
Transmitter.

Troubleshooting -

www.ebodeelectronics.eu
July 2009
please check FAQ and technical support on
page 7
Ref : EMML
EMML