Epson TM-U675 Bedienungsanleitung Seite 13

Follow the steps below:
1. Load a paper roll in the printer; turn off the power; then open
the paper roll cover and turn the power back on while holding
down the RELEASE button.
2. Press the RELEASE button seven times; then close the paper roll
cover. The printer prints the following message on receipt
paper and the SLIP light flashes.
3. Insert the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is
inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
4. When the sheet is ejected, press the RELEASE button, and
remove the sheet from the printer.
Notes on Using the MICR Reader
Do not install the printer near any magnetic fields. Be especially
careful where you install your display device and be sure to check
the recognition rate of the MICR reader with the display device in
place.
Make sure that the printer is not subjected to any impact or
vibration when it is performing a MICR reading.
TM-U675/U675P Specifications
Print method:
Print font:
Columns:
Character size:
Character sets:
Print speed:
Paper dimensions:
9-pin serial impact dot matrix
5 × 9 / 7 × 9
37 / 50 columns (receipt)
45 / 60 columns (slip/validation)
1.56 mm × 3.1 mm / 1.24 mm × 3.1 mm {0.006" × 0.12" / 0.49" ×
0.12"}
95 alphanumeric, 37 international characters
128 × 12 pages extended graphic characters
Approximately 5.14 LPS (40 columns at 17.8 CPI)
TM-U675/TM-U675P User's Manual 11
English