Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After clean it up you should drop in 3-4 drops of lubricating oil and then enclose the removed bit tool
again (do remember : you must aim at slot position when you hear click , you can make sure you have
assembled it correctly)
❏ Pay attention to
-
Do not disassemble the product by yourself
-
Do not clear the product with water or keep in damp places
-
Please clear it with a little wet cloth ot mild soap solution
-
Do not charge it above 40°C heat source or in the sub -zero temperature
-
It's normal that the product is overheated when it's charging
-
Do not use it to shave damp hair (it will lead to a short circuit and shorter service life of tool
bit)
-
Rechargeable nickel cadmium batteries are built in the product so please take out the battery
before you throw it away and put it on the place designated by the government or recycling
units with and environmentally friendly method
Werbung
