Initial Configuration Of The Network Settings; Establishing A Connection To The Network Interface; Starting The Web Application - Guntermann & Drunck MultiPower-12-HP Installationsanleitung

Initial configuration of the network settings

Initial configuration of the network
settings
The basic requirement for accessing the web application is the configuration of the
network settings of the device on which the web application is operated.
NOTE:
In the defaults, the following settings are pre-selected:
 IP address: address is obtained via
 global network settings: settings obtained using

Establishing a connection to the network interface

How to connect a computer to the network interface of the central power supply:
1. Use a category 5e (or better) twisted pair cable to connect the network interface
of any computer to the central power supply's Network interface.
2. Make sure that the IP address of the computer's network interface is part of the
subnet to which the IP address of the device belongs.
NOTE: Use the IP address 192.168.0.100, for example.
3. Turn on the central power supply.

Starting the web application

How to configure the settings of a network interface:
1. Start the computer's web browser and enter the URL
10 · G&D MultiPower-12-HP
(fallback: IP address 192.168.0.1)
DHCP
DHCP
192.168.0.1
in the address line.