Setting The Temperature Set Point; Automatic Operation; Manual Operation - Campa CAMPAVER BAINS 3.0 Installation Und Betriebsanleitung

5. HOW TO USE YOUR APPLIANCE (CONTINUED)

5.2. Setting the temperature set point

- The dial
MANUEL
- If the set point temperature is comfortable for you, it can be memorised by pressing and
holding the
MANUEL
NUEL
- To adjust the temperature to its optimum value, it must be allowed to stabilise for a few hours
while keeping the room closed.
MANUEL
During adjustment, an indicator light helps to monitor and adjust the
desired temperature according to its impact on power consumption.
This setting is available in Comfort mode (manual or automatic).
5.3. Automatic operation, «Smart» button
Pressing the
MANUEL
(Comfort and Eco time slot programming) and your adjustment preferences (preferred set
point temperature, absence detection, etc.).
MANUEL
Your automatic adjustment preferences can be memorised by pressing and holding the
key for 3 seconds.
MANUEL
By default, the saved setting is: 19°C as the preferred temperature with open window
detection and absence detection enabled.
MANUEL
5.4. Manual operation, «manual» button
- By pressing the
- Automatic functions are disabled (absence detection, programming and temperature
reduction commands sent via the Pilot Wire), and the appliance is set :
• Either in Comfort mode (the desired temperature can be adjusted)
• Or in Eco mode (recommended if you are away for a short time)
• Or in Frost-Free mode (recommended if you will be away for more than 24 hours)
increases or decreases the desired temperature.
key for 3 seconds.
button allows automatic operation according to your heating schedule
button you can control the automatic operation.
Page 47