Installing The Attachment Brackets; Installing On Or Under A Desk - Tascam AE-4D Bedienungsanleitung

Gigabit link status indicator
0
Orange indicates that a gigabit Ethernet link has been
established.
Link status/activity indicator
q
Green indicates that a link is established between the
devices.
Blinking indicates that signals are being transmitted be-
tween the devices.
DC IN 12V connector
w
Connect a PS-P1220E AC adapter (sold separately) here.
Cord holder
e
When using a PS-P1220E AC adapter (sold separately),
hook its cord here to prevent accidental disconnection.

Installing the attachment brackets

By installing the included attachment brackets on this unit,
you can fix it in place on top of or underneath a desk, for
example.
1.
Remove the four screws installed in the left and right
sides of the enclosure.
2.
Align the included attachment brackets with the enclo-
sure.
NOTE
When installing this unit on a desk, align the brackets as
shown in the illustration below.
3.
Use the four removed screws to install the attachment
brackets on the unit.

Installing on or under a desk

To install this unit on or under a desk, use 4 commercial-
ly-available screws that are suitable for the material and
thickness of the desk.
NOTE
The width of the attachment bracket openings is 7.1 mm.
See the dimensional diagrams at the end of this manual
for details about the attachment brackets.
1.
With the two attachment brackets already installed on
the unit, align the unit with the desk as desired.
2.
Make marks where the screw holes will be made in the
desk.
3.
Drill pilot holes for the screws in the desk.
4.
Attach the unit to the desk with 4 screws.
9
TASCAM AE-4D