ARESA AR-3460 Bedienungsanleitung Seite 6

ENGLISH
• The appliance must be used only with the stand supplied with it. It is forbidden to use it for other purposes.
• Avoid contact with hot surface of the electric kettle. Always take an electric kettle only by the handle.
• Before switching on make sure that the lid is tightly closed, otherwise the automatic shutdown system will not work when boiling and water can splash out.
• Make sure that there is at least a minimum amount of water in the electric kettle. It is forbidden to use an electric kettle without water.
• Do not fill the appliance with water above the maximum level mark. Otherwise boiling water can spill out from the spout.
• WARNING: Do not open the lid while water is boiling. Be especially careful if you open the lid immediately after the electric kettle boiled: the steam coming from the
electric kettle is very hot. Boiling water can cause severe burns. Be especially careful when there is hot water in the electric kettle. Do not touch the body of the electric
kettle during and immediately after heating, because he is very hot.
• ATTENTION: You should not remove the electric kettle from the stand during operation, first turn it off. • It is recommended to use bottled or filtered drinking water.
• If hard water is used, small spots may appear on the heating element of the electric kettle. This is the result of scaling. The harder the water, the faster the scale appears.
Scale can have different colors. Although the scale is harmless to health, it can affect the operation of your electric kettle. Regularly clean the electric kettle from scale.
• Moisture can condense on the electric kettle stand. This is normal and does not mean malfunction of the device.
• The appliance should only be used for household purposes in accordance with these operating instructions. Electric kettle is not suitable for industrial or commercial use.
The guarantee does not apply for malfunctions caused by the use of the product for purposes that go beyond personal household needs (ie for industrial or commercial
purposes. • Keep this manual.
Attention! The electric kettle should be used only in an upright position on a dry, solid and heat-resistant surface.
There are 6 buttons on the stand used for selecting and activation the heating modes. Each button has a light indicator (glowing rim around the button).
The buttons with the temperature indications 70°C, 80°C, 90°C and 100°C allow you to select the temperature to which the kettle heats the water.
"On / off" button is for turning on the selected heating mode and for turning off the kettle. When it is pressed to heat the kettle, it lights up in red light. When it is pressed
to stop the heating, it lights in green.
To heat the water to the temperature you need, press the button with the temperature indication and then "On / off" button.
To heat the water and maintain it at the temperature you need, press the button with the temperature indication, "Keep warm" button and after that "On / off" button.
To turn off the kettle, just press "On / off" button. At the same time, the button will turn green.
"Keep warm" button enables the function of maintaining temperature for the modes 70°С, 80°С, 90°С.
When placing / removing the kettle from the stand, pressing the buttons on the stand and automatically shutting it off, the kettle beeps.
Preparing for work. Place the stand on a flat horizontal surface and connect it to the power supply. You will hear sound signals and all indicators will blink.
Boiling water. Remove the electric kettle from the stand, open the lid and fill it with water. Make sure the water level is between the maximum and the minimum marks on
the water level indicator. Do not turn on the empty kettle. The electric kettle has protection against overheating when turned on without water. When the kettle overheats,
the protective device is activated which turns the kettle off in case if there is no water or if the water level is too low. If you accidentally turned on the kettle without water,
and the protection activated, wait about 15-20 minutes, and it will return to working condition.
ATTENTION! Turning on the appliance without water can lead to failure of the protection, so always make sure that there is enough water inside the kettle.
Close the lid and place the kettle on the stand. Avoid contact with hot steam. Press "100 ° С" and "On / off" buttons on the stand (if the kettle is in standby mode, then
you can press "On / off" (On / off) button immediately. The corresponding indication will light up and water heating will start. When the water boils, the kettle will beep and
automatically turn off. If you need, you can turn off the kettle manually until the boiling process is completed by pressing "On / off" button.
ATTENTION! Never open the lid before or immediately after boiling.
Water heating. Use 70°C, 80°C, and 90°C buttons to select heating temperature, then press "On / off" button. The indicator of the selected mode will blink, and the
indicator of On / off button (on / off) will be on. At the end of heating the indicator will stop blinking, the kettle will beep and turn off. To turn off the kettle manually, press
On / off" button.
'Keep warm' function. Use the buttons 70°С, 80°С and 90°С to select the heating temperature, then press "Keep warm" button and then "On / off" button. To turn
off the heating mode, press "On / off" button again. If you remove the kettle from the stand for less than 1 minute, the temperature maintenance mode will remain on. If
the kettle is removed for a longer time, it will beep and the mode will turn off. If the water temperature in the kettle exceeds the temperature of the selected mode, then
"Keep warm" function cannot be turned on. For example, you cannot turn on heating to 70 ° C, 80 ° C and 90 ° C if you have just boiled water. You will need to wait until
the water is cooled down.
TRANSPORTATION. Transport the device by any kind of enclosed transport observing the rules which ensure preservation of market condition of both the product and
packaging, and its further safe operation.
CLEANING. Remove the plug from the outlet before cleaning or servicing the electric kettle. If the kettle was in use, cool it down for at least 40 minutes. To avoid electric
shock do not immerse the kettle, its stand and power cord in water. These parts of the device can be cleaned with a slightly damp, soft cloth and without adding any
cleaning agents. In areas with a high degree of water hardness it is necessary to remove scale from the appliance regularly in order to maintain it in good condition, as
excess scale can lead to malfunction or breakage. The frequency of descaling depends on the degree of hardness of tap water in your area and on the frequency of use
of the kettle (for example, one cleaning after 200 times of use). If the water in your house is stiff, we advise you to filter it - this will reduce the formation of scale.
STORAGE. The device must be stored indoors, in conditions that presume its further safe operation. Make sure that the appliance and all its accessories are completely
dried before storing it. Always store the device in an upright position.
When purchasing the product, ask for it to be checked in your presence. Without having a warranty card or when it is not properly filled in, the quality claims are not
accepted, and no warranty repair is performed. The warranty card should be presented at any address to the service center during the whole warranty period. The product
is accepted for service in a complete set only. The warranty period is calculated from the moment of sale to the buyer. Keep the documents confirming the date of purchase
of the product (cash receipt).
The condition of free warranty service of your product is its correct operation, which does not go beyond personal domestic needs, in accordance with the requirements
of the operating instructions for the product, the absence of mechanical damages and the consequences of careless handling of the product.
The product is accepted for warranty service in its pure form. The warranty covers all manufacturing and construction defects (except those listed in the "Warranty does
not apply" section), identified during the warranty period. During this period defective parts, except consumables, are subject to free replacement in the warranty service
center.
1. Defects caused by force majeure.
2. Damage to the product caused by the use of the product for purposes that go beyond personal domestic needs (ie industrial or commercial purposes).
3. Consumables and accessories.
4. Defects caused by overloading, improper operation, penetration of liquids, dust of insects, ingress of foreign objects into the product.
5. Products that have been repaired outside authorized service centers or warranty workshops.
6. Damage resulting from changes in the design of the product by the user or unqualified replacement of his components.
7. Mechanical damages, including due to negligent handling, improper transportation and storage, falling of the product.
8. Violation of the operating instructions.
9. Incorrect installation of mains voltage (if required).
10. Making technical changes.
11. Damage through the fault of animals (including rodents and insects).
Information on the production date can be found on a separate package.
For warranty service, please contact your nearest service center.
CONSTRUCTION OF THE DEVICE
OPERATION
TRANSPORTATION, CLEANING AND STORAGE
WARRANTY TERMS
THE GUARANTEE DOES NOT COVER: