Belle PCX 20a Bedienungshandbuch Seite 11

WARNING
the left. If restarting a warm engine, the choke is usually not required, however, if
the engine has cooled to a degree, partial choke may be required.
4. Set the throttle to the idle position by moving the throttle lever fully to the right. Do
not start the engine on full throttle, as the compactor will vibrate as soon as the
engine starts.
handle with the other. Pull the recoil starter until engine resistance is felt, then let
starter return.
Engine will not start.
Engine still will not start
Unit will not vibrate.
Bituminous surface
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Major Fault
Engine speed too slow.
Drive belt tension loose.
Drive failure.
Vibrator failure.
Over compaction.
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
Contact Agent or Altrad Belle.
Set engine speed control to fast.
Adjust belt tension
Contact Agent or Altrad Belle.
Contact Agent or Altrad Belle.
Remove and relay.
11
GB
GB