Hama 00053192 Bedienungsanleitung Seite 13

1. The Tutorial section (on the right of the screen)
describes the settings available on that screen.
2. Click the Next or Back buttons at any time to move
through the Confi guration Wizard screens.
3. The following is a description of the Wizard screens:
Conn Summary: shows cable connection, and allows
you to select a different output.
Password Setup: allows you to create a password to
keep others from changing your confi guration. The
Password restricts access to Advance and Internet
Settings. Password can be up to 32 characters in
length.
Device Settings: allows you to change the wireless
device name broadcast by your WBA device.
Wireless Settings: allows you to select wired or
wireless Internet connection, and to enable secure
wireless access by entering an encryption key.
If your Broadband Router uses secure wireless
communication, you need to use the same key as the
one in use by the Broadband Router in order to access
the Internet.
If your confi guration matches B, select "Connect to
external networks using wired Ethernet" option.
If you are using Confi guration C or D, select "None"
as an option in Wireless Settings window. In this case,
all the Internet accesses take place directly between
the PC and the Broadband Router.
Summary: displays summary of the selections made
and connections between various devices.
4. Click the Cancel button at the bottom of the screen to
exit the Confi guration Wizard at any time. To save any
confi guration changes you have to click Finish.
Starting and Stopping the WBA Software
1. Click on the WBA icon on the Windows desktop
(or from Start/All Programs) – the application
automatically scans for WBA devices.
2. If only one WBA device is detected, connection
between the PC and the WBA device will be made
automatically.
• The default is set for Connect via Wireless ID
(Confi gurations A and B).
• If you want to connect over Ethernet instead, click
on "Connect via Direct connect ID", and click on the
Connect button.
12
• If multiple WBA devices are detected, the Wireless
Display List is presented. Select the device you want,
and click on the Connect button. If your display is not
shown on the list, press the "Refresh" button until it
appears.
• Once connected, it will display, "Connected to:
WBA-xxxx" in the main application.
• To change from one WBA device to another, or to
change between wired and wireless connection with
your PC, click on Select TV, which will bring up the
WBA Display List.
• To stop the display and disconnect your PC from the
WBA device, click on the "X" button on the upper right
corner of the WBA application window, and click on
OK when prompted.
Changing Video and Network Settings
1. The Main menu of the WBA application provides the
following information about the WBA connection:
Connection Status – displays the name for the
connected WBA device.
Signal Strength – four or more green bars indicate
a strong wireless signal.
Display Modes – changes the display mode.
Video – select this when viewing a video.
This provides high frame rate at lower resolution.
Photo – select this when viewing graphics or photos.
This provides higher resolution at a lower frame rate.