Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Location
To ensure appliance's best functionality, you should not
install the appliance in the nearby of the heat source
(oven, stoves, radiators, cookers or hobs) or in a place
with direct sunlight. Make sure that air can circulate
freely around the back of the cabinet.
This appliance should be installed in a dry, well
ventilated indoor position.
This appliance is intended to be used at ambient
temperature ranging from 10°C to 38°C.
The correct operation of the appliance
can only be guaranteed within the
specified temperature range.
If you have any doubts regarding where
to install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
It must be possible to disconnect the
appliance from the mains power supply.
The plug must therefore be easily
accessible after installation.
Electrical connection
•
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
•
The appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
Control panel
2 1
2
1
1. Fridge temperature indicator LED
2. Freezer temperature indicator LED
3. FastFreeze indicator
2 3
2 4
5
2
7
4
6
3
in compliance with current regulations, consulting a
qualified electrician.
•
The manufacturer declines all responsibility if the
above safety precautions are not observed.
•
This appliance complies with the E.E.C. Directives.
Ventilation requirements
The airflow behind the appliance must be sufficient.
min.
5 cm
200 cm
Caution! Refer to the installation
instructions for the installation.
Door reversibility
Please refer to the separate document with instructions
on installation and door reversal.
Caution! At every stage of reversing the
door protect the floor from scratching
with a durable material.
4. Freezer compartment indicator
5. Fridge compartment indicator
6. ON/OFF button
Compartment selection button
7. FastFreeze button
Temperature regulator
Switching on
1. Insert the plug into the wall socket.
2. Touch the ON/OFF button (6) if all LED indicators
are off.
Switching off
Keep touching the ON/OFF button (6) for 3 seconds.
All indicators light off.
2
min.
200 cm
2
7
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
