Operation; Assembly; Operation Instructions; Operating - Zipper Maschinen ZI-CWP750N Betriebsanleitung

13

OPERATION

13.1 Assembly

 Screw the hose adapter (5) into the pump outlet
 Fix a hose to the hose adapter.
The hose adapter can be trimmed to suit the selected hose
connection.
 Mount the suspension bracket (if fitted) and adjust the length.

13.2 Operation instructions

 Perform all machine settings with the machine being
disconnected from the power supply!
 Make sure that the immersion pump is standing securely or
operate the immersion pump suspended from a rope.
 Make sure there is adequate clearance under the pump.
 Never allow the immersion pump to run against a closed off
hose line.
 When using in shafts, make sure the size is adequate.
 Always cover the shaft with a secure footplate.
 The immersion pump switches on automatically using the float
switch when a specific water level has been reached, and
switches off again if the water drops below the switch-off
height.
 Recommended cable length on the float switch approx. 120
mm.

13.3 Operating

 Unwind the connection cable (2) completely.
 Make sure that the electrical plug connection is mounted in
the area safe from flooding.
 Change the terminal position and adjust the switching
points of the float switch (6) individually.
 Attach the cable on the float switch to the pump housing
securely.
 Immerse the immersion pump in the conveying medium
slowly. Hold the immersion pump at a slight angle to allow
any air to escape.
 Insert the mains plug into the plug socket.
 To switch off remove the mains plug from the plug socket.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-CWP750N / ZI-RTP350
W A R N I N G
OPERATION
15