Sage the Nutri Juicer BJE410 Kurzanleitung Seite 12

TROUBLESHOOTING
POSSIBLE PROBLEM
Pulp too wet and
reduced extracted juice
Juice leaks between the
rim of the Juicer and the
juicer cover
Juice sprays out
from spout
Overheating with
excessive loads.
12
EASY SOLUTION
• Try a slower juicing action. Remove the stainless steel filter basket
and thoroughly clean mesh walls with a cleaning brush. Rinse the
filter basket under hot water. If the fine mesh holes are blocked,
soak the basket in a solution of hot water with 10% lemon juice to
unlock the holes or wash in the dishwasher. This will remove excess
fibre build up (from fruit and vegetables) which could be inhibiting
the flow.
• Try a slower juicing speed and push the food pusher down the feed
chute more slowly.
• Ensure all parts are securely pieced together, with the interlocking
arm in place.
• The juice is being extracted too fast: try a slower juicing speed and
push the food pusher down the feed chute more slowly.
• The juicer is fitted with a safety device which safeguards against
overheating with excessive loads. If overheating occurs, the juicer
will automatically activate the overload protection device and the
unit will switch itself off. When the overload protection is activated,
unplug the Juicer from the power outlet for at least 15 minutes to
allow the unit to cool. Then plug the juicer into the power outlet and
use as normal.
• It is important to ensure the juicer is turned on and the motor is
running prior to loading the chute. Do not put excessive loads in the
feed chute and ensure the filter basket is totally clear of any food
build up, on the blades and mesh, as this can result in unnecessary
resistance against the motor resulting in overheating.