Color Settings - Laserworld SwissLas Purelight PL-3000RGBNL Bedienungsanleitung

Manual: PL-3000RGB

8.5 Color settings

By the menu item „COLOR" settings adjustments of colors can be conducted (multicolor pro-
jectors). If necessary single colors can be switched off completely. Theses settings are complet-
ly independent of control software und also work in Stand-Alone Modes.
Menu option COLOR R : Set red color channel
Menu option COLOR G: Set green color channel
Menu opiton COLOR B: Set blue color channel
Menu option MASTER:
Set brightness (all colors) of projector.
8.6 Display of Operating Hours Counter
The operating hours counter shows runtime of device until now. It is the actual operating time
of the diodes, starting when the device is connected to the mains and the main switch is acti-
vated. Also time of the standby mode is counted (wearout of diodes).
It is normal that our projectors show an inital term up to 10 hours at delivery. This is a result of
extensive tests of quality assurance purposes.
9. Network Connection Settings
System requirements:
• 100MBit network card (100BASE-TX) or faster
• Wireless transmission: at least 54MBits/sec. (only by an external access point)
Factory Settings:
The network card of projector has the static IP address: 192.168.0.100 as a standard.
Connection and Cabling:
Connect projector by a conventional network cable (at least CAT5 recommended) to a PC.
Cross-over-cables are also usable (Auto MDI/MDIX).
page 10 / 34
/ PL-6000RGB / PL-12.000RGB
NL NL NL