Maintenance / Cleaning; Troubleshooting - Laserworld Club Serie Bedienungsanleitung

Manual / Bedienungsanleitung: CS-800 G
1 2 4
e.g. 1000 0000 01, DMX mode address 1 (1+0+0+0+0+0+0+0+0+0)
0010 0100 01, DMX mode address 36 (0+0+4+0+0+32+0+0+0)
DMX control
channel
1
2
3
4
5
6
7
8
9
10
11
Please note that not all effect channels are available for all patterns. E.g. you can't zoom dynamic patterns, etc.
Channel 3 (strobe) is also available when in soundmode (channel 1 70-209).
ILDA mode
When an ILDA compatible interface is connected to the laser, the laser is automatically switched to ILDA mode.
Output is then controlled by a PC running laser control software. The scanners are set for ca. 10000 PPS at 20-
25° optical. When running faster, reduce image size/scan angle.

Maintenance / cleaning

Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing top cover, remove 8 screws. Remove any deposits of dust, especially at the fan.
Check for condensed fog fluid inside. If so, clean and rearrange the position of laser and or hazer.
cleaning when a "halo" is noticeable around the beam or an unusual high amount of diffuse light can be seen
inside the device. Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the device is not
in use or before cleaning it.

Troubleshooting

Problem
No function / fan not working
Effects don't change to the beat of the music
Problems with DMX control
Device not working, but fan working
Laser does not switch to ILDA mode:

The interface does not connect pins 4 and 17 (Interlock) of the IDLA signal. See interface manual

The cable does not connect pins 4 and 17. Use a cable that connects pins 4 and 17.

Use an adapter that connects pins 4 and 17.
8 16 32
Function
Mode: 0-69 laser off; 70--139 sound mode; 140-209 animated
sound mode (see above); 210-255 DMX mode
Pattern
Effect channel: Strobe
Horizontal movement: 0 no effect; 1-167 (fixed) movement; 168-
188 animated movement left to right with increasing speed; 189-
209 dto. Right to left; 210-255 dto. left to right and back
Vertical movement: analogous to hor. movem.
Zoom: 0-10 no effect; 11-104 increasing size; 105-154 growing
with increasing speed; 155-204 dto. shrinking; 205-255 dto.
growing/shrinking
Width (rotation about y): 0-150 fixed rotation; 151-255 automatic
rotation with incr. speed
Height (rot. About X): analogous to width
Rotation: 0-180 fixed rotation; 181-217 automatic with incr. speed
clockwise; 218-255 do. counter clockwise
Blanking: 0-70 no effect; 71-139 points are brighter; 140-209
dashed lines; 210-255 points only
Wave
64 128 256
Possible cause
Check mains connection
Adjust sensitivity with the dial on the back.
Check if device isn't in DMX or autom. mode
Check DMX address selection
Turn device off for ca. 1 minute.
4 / 10
Mirrors need
Version 04.06.13