Menu Structure - OHAUS TD52P Bedienungsanleitung

EN-4
2.2.1 Opening the Housing
CAUTION: ELECTRICAL SHOCK HAZARD. REMOVE ALL POWER CONNECTIONS
TO THE
CONNECTIONS. THE HOUSING SHOULD ONLY BE OPENED BY AUTHORIZED
AND QUALIFIED PERSONNEL, SUCH AS AN ELECTRICAL TECHNICIAN.
TD52P
Remove the four Phillips head screws from the rear housing.
Remove the front housing being careful not to disturb the internal connections.
Once all connections are made, reattach the front housing.
TD52XW
Remove the four hex head screws from the rear housing.
Open the housing by carefully pulling the front housing forward.
Once all connections are made, reattach the front housing.
The screws should be tightened to 2.5 N•m (20-25 in-lb) torque to ensure a watertight seal.
2.2.2 RS232 Interface Cable to TD52XW
Pass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal
block J7 (Figure 1-3, item 6). Tighten the strain relief to maintain a watertight seal.

3. Menu Structure

Calibration Setup
Zero Capacity Unit
Span Range
Linearity
GEO
Language
Power On Zero
Power On Unit
Key Beep
Transaction Counter
Next Transaction
Password
Reset
Weighing Unit GLP/GMP Data
kg Date Format
lb Date
g Time Format
oz Time
lb: oz Project ID
t Scale ID
ton Reset
Custom Unit
Reset
* Sub- menu for options will be active only when the specific board is installed.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by
OHAUS is under license.
INDICATOR
TABLE 3
>|1|< Capacity
Capacity
>|1|<Graduation
&
Graduatio >|2|< Capacity
n
>|2|<Graduation
Communication
RS232
*2nd RS232
*RS485
*Ethernet
*Wifi
*Bluetooth
*Analog
BEFORE SERVICING
MENU STRUCTURE
Read Out
Stability
Zero Range
Filter Level
Auto Zero Tracking
Auto Dim
Brightness
Screensaver
Auto Off
Adjust Contrast
Reset
SDCARD
Library
Memory
User
®
OR MAKING INTERNAL
Application
Mode
Weighing
Counting
Check
Percent
Dynamic
Reset
Maintenance
Export Menu
Import Menu
Diagnosis
Service Menu