Control Functions - OHAUS TD52P Bedienungsanleitung

EN-2

1.3 Control Functions

Button
Figure 1-2
Action
Short press: If the terminal is Off, power on the terminal; if the terminal is On, clear the
data input.
Long press: Power off the terminal.
Short press: Send the current display value to RS232 port or Option when properly
enabled.
Long press: Change the current weighing unit. Press and hold the key to scroll through
the list of enabled units. Release the key to switch to the unit selected.
Short press: Press the key to enter the Library.
Long press: Press and hold this key to change weighing modes. Press and hold the key
to scroll through all weighing modes. Release the key to switch to the mode selected.
Short press: Press the key to enter user profile.
Long press: Press the key to enter user menu.
The 5 Softkeys correspond to several icons at the bottom of the display area. These
icons indicate for each Softkey functions specifically available for configuration and
operation of the mode.
To enter '2'-'9', press the numeric button in the mode of numeric input.
1
2
3
4
5
6
TD52XW Indicator
TABLE 1-2 TD52XW PARTS
Item Description
1 Control Panel
2 Front Housing
3 Screws (6)
4 Adjusting knobs (2)
5 Rear Housing
6 Mounting Bracket
7 Load Cell Connector
8 Strain Relief for Option
9 Power Cord
10 Strain Relief for Option
7
10
8 9