Settings; Connection And Configuration Of An Oxts Rt Sensor - DTC RTK Modem V1 Bedienungsanleitung

6

Settings

6�1 Connection and configuration
of an OxTS RT sensor
1. Connect the modem to the 15-pin con-
nector J3 (radio) on the breakout cable
EN
of the RT.
Use the supplied data cable.
26
2. Plug the other end into the COM port
connector on the front of the modem.
3. Start the OxTS software
NAVconfig.
4. Make the settings that you see in the
following screen:
(It is essential that you tick the check box
for "Enable NTRIP corrections")
Settings