Presentation; Use - Chauvin Arnoux K Serie Bedienungsanleitung

1. PRESENTATION

The mains adapter is an accessory that is used to supply your sensor or probe rom a mains plug.
It consists o a mains unit, a connection cable and a semi-housing. This accessory is designed or use
on K housings.
Figure: the outer and inner sides o the adapter housing:
2
1
Outer side Inner side

2. USE

To install the adapter, proceed as ollows:
Step 1:
Make sure that your device is not connected to an installation or measurement device.
Step 2: Remove the housing.
1. Use a screwdriver to unscrew the two screws at the back o the housing.
2. Open the housing.
3. Remove the battery.
Step 3: Install the adapter.
1. Connect the 9 V battery connector to the terminals inside the adapter housing (see above fgure, re .2).
2. Set the switch to OFF.
3. Close the housing and screw both screws back in.
4. Select the label in accordance with your model and a fx the label to the ront o the housing
(see above fgure, re .1).