General Description - urmet USB/KEY Bedienungsanleitung

ENGLISH
WARNING: This document provides only some essential product information. Refer to the 1067 control
panel manuals for more detailed information.

GENERAL DESCRIPTION

The 1067/003 interface is used to connect a computer to the 1067 control panel in order to program the
computer and a USB flash drive or memory key (Pen Drive) to save and retrieve the whole system
programming, the history of events, codes and keys.
CONNECTIONS TO THE 1067 CONTROL PANEL
Insert the supplied Flat cable into the polarised connector in position A as shown in Fig. 1 (after removing
the jumpers and with control panel not powered).
A
Fig. 1
HOW TO USE THE USB FLASH DRIVE (FLASH MEMORY IN PEN
DRIVE)
The 1067/003 Interface is capable of managing FAT12, FAT16 and FAT32 (not NTFS) USB Flash
Memories and has a maximum input of 100mA @ 5V.
It has been tested on Flash memories up to 16GB with single partition.
The data "Saving" and "Recovery" operations can be carried out when the control panel is in "Maintenance"
mode.
Refer to the system "Programming Manual" to carry out these operations.
Given this condition, the USB LED (fig.2) flashes to signal that the USB Memory Key has been recognised.
The light remains on until the operations are completed.
WARNING: Never remove the USB Memory Key during data writing o reading!
USB LED
PC LED
Fig. 2
4 DS1067-019B