Re-Syncing The Transmitter And Receiver - AEI DigiSender DGXDSDV112-EU Handbuch

(EN) ENGLISH
DGXDSDV112 - DigiSender® XDHDMI - Single Input HDMI AV Sender System
Using your DigiSender® XDHDMI

Re-syncing the Transmitter and Receiver

Should you need to re-sync the Transmitter and Receiver at any point, this can be achieved by follow-
ing the instructions below.
1.
Turn on both the Transmitter and the Receiver.
Please note that because you need to hold the Pair Button on both the Transmitter and Receiver simulta-
neously, you will need to have the Transmitter and Receiver in the same room as each other and within
reach. Alternatively, if you have someone that can help, they can hold the Transmitters Pair Button in the
lounge while you hold the Receivers Pair Button in the bedroom.
Page 12
2.
IR
Press and hold the 'Pair' button on the back of the
DigiSender® Transmitter and Receiver, simultane-
ously, for 5 seconds and then release.
Please read the instructions carefully prior to installation
PAIR
HDMI IN
PAIR
HDMI OU A