Power Supply - Stanley SL3WAKS Anweisungshandbuch

• Do not use the appliance if any part is damaged or defective.
• Have any damaged or defective parts repaired or replaced by the manufacturer.
• Never attempt to remove or replace any parts other than those specified in this manual.
specific safety instructions for spotlights
• Allow the spotlight to fully cool down before storage.
• Keep combustible materials away from spotlight lens. Extreme heat can cause fires.
• Never place the light face-down on any surface when it is switched on or cooling.
• Do not leave the spotlight unattended. Keep children and animals away from the work
area.
• Inspect the lens for damage following impact or if the spotlight is dropped. Do not operate
without the lens in place or with a damaged lens.
• The lens is manufactured from glass. The lens may crack or break if subject to an
impact. If the lens is damaged it must be replaced by manufacturer.
• Never look directly into the light or shine the light into another person's eyes.
additional safety instructions for batteries
WARNING:
Batteries can explode, or leak, and can cause injury or fire. To reduce this
risk:
• Carefully follow all instructions and warnings on the battery label and package.
• Always insert batteries correctly with regard to polarity (+ and –), marked on the battery
and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries. Replace all of them at the same time with new
batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals inadvertently come
in contact with conductive materials such as keys, coins, hand tools and the like. So when
transporting individual batteries, make sure that the battery terminals are protected and
well insulated from materials that could contact them and cause a short circuit."
ENGLISH
SL3WAKSEU_Manual_040612.indd 4-5
4

Power suPPly

The unit is powered by four "AA" alkaline dry cell batteries (may be sold separately).
Unscrew the end cap on the back of the unit (counter-clockwise) and remove it. Insert
batteries as described in compartment. Replace the end cap on the unit by first aligning
the two grooves of end cap to fit over the two ribs in the battery compartment; then
screwing the end cap in a clockwise direction to secure. Do not over-tighten.
Note:
Use only "AA" alkaline dry cell batteries in this unit.
cAutION: When replacing the "AA" alkaline dry cell batteries: do not mix old and new
batteries. Always insert batteries correctly with regard to polarity (+ and –), marked on the
battery and the equipment. Remove dead batteries immediately and dispose of per local
codes.
features
1. 3 watt LED bulb
2. Rubber ring guard
3. On/off Trigger
4. Low battery voltage LED indicator
5. End cap
6. Trigger lock
7. Pistol grip
8 Battery compartment containing four (4) "AA" alkaline dry cell batteries (may be sold
separately)
9. Ribs (align and fit into the two corresponding grooves in the end cap)
10. End cap detail showing grooves
use
operating the spotlight
The on/off trigger turns the unit on and off, and is also used to choose either the high or
low brightness setting.
1. Press and hold the on/off trigger once to use the spotlight in its high (brightest) setting.
2. Release the on/off trigger to turn the unit off.
1. Press the on/off trigger twice, then hold the trigger, to use the spotlight in its low
(dimmest) setting.
2. Release the on/off trigger to turn the unit off.
or
5 ENGLISHn
4/6/2012 12:15:35 PM