Strack PowerMax SN5650-PMO-0065 Bedienungsanleitung Seite 50

PowerMax cam unit SN5650-PMO-0065 — SN5650-PMO-0260
1. Security advices. Please absolutely consider!
Before mounting and initial operation and all further works at the STRACK PowerMax cam please
absolutely read the following safety instructions.
The cam has to be used according to these operating instructions. If new operating instructions will be
established, this version loses its validity.
Service and maintenance works at the mounted STRACK nitrogen-gas springs may only be effected by
persons trained and instructed by STRACK NORMA with good professional knowledge.
If the mounted STRACK nitrogen-gas spring is used incorrectly or not for the intended application, menace:
For all operations at the STRACK side cam, the valid Ordinance on Industrial Safety and Health paragraph 3
has to be considered.
Press, tool and peripheral devices have to be suited, prepared and adjusted for the application of the
STRACK side cams.
Attention:
Before and during the service- and maintenance operations at the tool respectively
at the STRACK cam there is an increased risk of accident. Therefore these operations
may only be effected at cam units which are driven back.
Seized cam units at faultless gas springs can cause an abrupt decompression.
Thus they can be an injury risk.
Damaged gas spring may not be used again. The exchange of individual parts has to be agreed with STRACK
NORMA.
4
STRACK NORMA GmbH & Co. KG · Königsberger Str. 11 · D-58511 Lüdenscheid · Tel +49 2351 8701-0 · www.strack.de
Dangers for the health
Dangers for the STRACK nitrogen-gas springs
and other property holdings of the operator,
Dangers for the efficiency of the STRACK nitrogen-gas springs.
PowerMax
I
Operating instructions -- PowerMax cam unit PMO