Operation - Ribimex RIBILAND RBAT20 Bedienungs- Und Wartungsanleitung

V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens.
- The product is intended for cutting hedges, shrubs within the limits of its characteristics.
- This tool may not be used to do other things outside of the described scope in this manual.
- Do not use the machine for unsuitable purposes (for ex. for cutting wood ...). Do NOT operate on
damp or wet working area.
- The tool is not intended for artisanal, commercial, professional and/or industrial use (for ex.: in
public parks...).

5.2- Operation

Before any operation:
-- always visually inspect that the product does not show signs of use or damage
-- check that the screws, bolts and nuts are well tightened.
-- replace any used or damaged part, and tighten firmly the screws, bolts and nuts when needed.
Important - Before starting work
- Remove the blades sheath.
- Check the blades proper operation. The blades work in opposite direction and have two cutting
sides to provide greater cutting capacity and performance.
- Repeat several times the starting and stoppage of the machine to become familiar with it.
- Make trial work on small shrubs or hedges to become familiar with handling the machine.
1. Ensure that battery is charged, otherwise proceed with charging.
2. Wear appropriate protective equipment.
3. Clear working area off any objects likely to pose a hazard.
4. Inform persons to stay away from working area and machine while you are working.
5. Firmly hold tool with both hands, and always maintain a balanced and secure position.
6. Place blade above the hedge. Do not make sudden movements.
7. Press switches (2) and (4) to start operation.
8. Once work is finished, stop product by releasing one of the switch (2) or (4).
Note: do not put down product until the cutting blades have completely stopped moving.
9. Replace the blades sheath after use.
I
MPORTANT
–
T
O PROLONG THE LIFE OF YOUR ENGINE
S
TART AND STOP THE ENGINE BY PRESSING AND RELEASING THE SWITCH GRADUALLY
ATTENTION! Do not assume of your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting
strict compliance to the safety instructions given with the tool.
Improper use of the tool or failure to comply with the provided safety instructions in this manual can
cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Remain alert about your surroundings and especially for any danger that you may not hear while
using the tool.
5.3- Tips
- The trimming cut will be improved if an angle of 5°, between the hedge and the blade, is kept
during the operation. (Fig.A)
DURING OPERATION
,
DO
NOT
USE BY PRESSING THE SWITCH WITH JOLTS
.
.
Page 28 / 78