Xiaomi Mi G10 Benutzerhandbuch Seite 15

FAQ
Error Possible Cause
It is out of battery or has low battery.
It enters into overheat protection mode
triggered by a blockage.
The vacuum cleaner does not work.
Its suction opening or airway passage is blocked.
The dust compartment is full and/or the filter
is clogged.
The suction power reduces.
The smart high torque brush bar and/or the
extension rod are blocked.
The main suction opening or the extension rod is
The motor makes a strange noise.
blocked.
The first indicator is red after Battery pack is damaged.
turning on the vacuum cleaner.
The first indicator blinks red when
The charger is incompatible.
charging the vacuum cleaner.
26
Solution
Fully charge the vacuum cleaner, then
resume use.
Wait until the vacuum cleaner cools down,
then reactivate it.
Clear any blockages from suction opening
or airway passage.
Empty the dust compartment and clean
the filter.
Clear any blockages from the smart high
torque brush bar and/or the extension rod.
Clear any blockages in the main suction
opening or the extension rod.
Please contact after-sales service to
arrange maintenance.
Only use the original charger to charge the
vacuum cleaner.
Error Possible Cause
The charger is not connected to the vacuum
cleaner.
The battery is fully charged and went into sleep
The battery indicator does not
mode.
light up while charging.
If the problem still persists after ruling out the above two possibilities, please contact after-
sales service for help.
The battery charges slowly. The battery temperature is too low or too high.
The water dispenser filter is clogged.
The water tank does not dispense
water, or dispenses water slowly.
The mop pad is dirty.
Solution
Make sure the charger is plugged in
correctly.
The vacuum cleaner can be used normally.
Wait until the battery temperature
normalizes, then resume use.
Clean or replace the water dispenser filter.
Clean or replace the mop pad.
27