Denver HBO-6750 Original Bedienungsanleitung Seite 12

- Never charge the product without supervision.
- The product should only be charged in temperatures between 0°C - +45°C.
- If charging at lower or higher temperatures, there is a risk that the performance of the battery will be reduced
and a potential risk of damage to the product and personal injury.
- Charge and store the product in an open, dry area and away from flammable materials (i.e. materials that
may burst into flames).
- Do not charge in sunlight or near open fire.
- Do not charge the product immediately after use. Let the product cool down for one hour before charging.
- If the product is left with other persons for example during a holiday period, it should be partially charged (20-
50% charged). Not fully charged.
- Do not remove the product from the packaging, charge it fully and then put it back into the packaging. When
shipped from the factory, the product has often been partially charged. Keep the product in a partially charged
state, until it is going to be used.
- Only use the DC connector to connect with the DC cable from the charger
that comes with the hoverboard.
- Do not insert any foreign objects into DC connector.
- Risk of arcing! Never bridge the DC charging with metal objects!
Chapter 7 The maintenance of the hoverboard
The hoverboard needs to be maintained. This chapter mainly describes the relevant steps and important
operation reminders to maintain it. Please make sure that the power and charge coil are off before you do the
following operation. You should not operate when the battery is charging.
7.1. Cleaning
Make sure the power and the charge coil are off.
Wipe the shell of hoverboard with soft cloth.
Make sure that water and other liquids do not enter the internal
parts of the balance scooter as this may permanently damage the
electronics/batteries of the scooter. There is a risk of personal
injury.
ENG 10