Balluff BAE SC-TL-F04 Betriebsanleitung Seite 63

Continuation „Serial Menu":
SERIAL PROTOCOL
Determines the sequence of characters send, when using the serial output for cyclic data
transmission under time control (xxxxxxx = value SERIAL VALUE).
Setting „1" removes the unit address from the string which allows a slight faster transmission
cycle.
0
1
SERIAL TIMER (S)
This register determines the cycle time in seconds for cycling transmission of SERIAL VALUE when
using the serial output. (On a serial request, the cycling transmission is stopped for 20 s)
0,000
...
60,000
SERIAL VALUE
This parameter defines the value to be transmitted.
Einstellung
0
1
2
3
4
5
6
7
8
9
10
11
www.balluff.com
Transmission report = Unit Nr., +/-, data, LF, CR
1 1 +/- X
Transmission report = +/-, data, LF, CR
+/- X
All cyclic transmission is switched off. The unit will send data upon a serial
request or with command SERIAL PRINT.
Cycle time in seconds.
Code Bedeutung
:0 Measurement_Result (Result after linking, scaling, filter, etc.)
:1 Converted_Output_Value (Parallel output data after conversion)
:9 Minimum_Value (Minimum value of Measurement_Result)
;0 Maximum_Value (Maximum value of Measurement_Result)
;1 Reserve
;2 Reserve
;3 Error Status (Reading the error code)
;6 Actual Speed ()
Actual Position (Start Stop: position [in µm] with offset without
;7
scaling)
;8 Actual Angle (Start Stop: e.g. angle with offset without scaling)
Raw Position (Start Stop: position [in µm] without Offset and
;9
without scaling))
;1 Parallel Output
X X X X
X X X X
X X LF CR
X X LF CR
21