MONTAGEABLAUF OHNE AUFBAUGEHÄUSE
ASSEMBLY PROCEDURE WITHOUT ADDITIONAL HOUSING
Montageausschnitt und
Bohrungen nach Zeichnung
anfertigen
Make mounting cut-out and
drill holes according to drawing
Ansicht von innen: das Kühlgerät mit
11 selbstsichernden Muttern M6 mit
Unterlegscheibe befestigen (7 Nm)
View from inside: fasten the cooler
with eleven self-locking nuts M6 with
washer (7 Nm)
8
Die Schutzfolie der Dichtung entfernen und das Kühlgerät in den
Ausschnitt einsetzen, so dass der Kühlkörper mit Lüfter,
Anschlussklemme und Gewindebolzen in den Schaltschrank hineinragen
Remove the protective film of the sealing and put the cooler into the
cutout so that the heatsink, fans, terminals and the threaded bolts
protrude into the enclosure.
Bei hoher Luftfeuchtigkeit und niedrigen Temperaturen im
Schrankinneren kann sich Kondensatwasser bilden. Abhängig von der
Einbauposition sollte die Kondensatbildung kontrolliert abgeleitet
werden (siehe Kondensatrinne aus dem Zubehör)
At high levels of humidity and low temperatures inside the closure,
condensation water can form. Depending on the installation position,
condensate formation must be drained off in a controlled manner (see
condensate through for accessories)
PK 300 PS + KRP 300
PK 300 PS + KRP 300