Wireless Network; Connecting The Fm Antenna - Samsung HT-D5000WXZF Handbuch

Connections

Wireless Network

You can connect to the network with a Wireless IP sharer.
1. A wireless AP/IP router is required to make a wireless network connection. Connect the wireless
LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
2. Set the network options. (See page 33)
Broadband
service
Wireless IP sharer
PC
✎
NOTE

This product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name:
WIS09ABGN).
- The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer for
purchasing.

You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable
operation of the wireless network.)

Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance,
distance, obstacles, interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

When applying the security key for the AP (wireless IP sharer), only the following is supported.
1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, AES

For the AllShare function, a PC must be connected in the network as shown in the fi gure.
FM Antenna (supplied)
FM ANT
HDMI OUT HDMI OUT
24
English
HT-D4500_ELS_1223.indd 24 HT-D4500_ELS_1223.indd 24
Networking with PC for
AllShare function
(See page 63)

Connecting the FM Antenna

1. Connect the FM antenna supplied to the FM ANTENNA
Jack.
2. Slowly move the antenna wire around until you fi nd a
location where reception is good, then fasten it to a wall
or other rigid surface.
✎
NOTE

This product does not receive AM broadcasts.
COMPONENT OUT COMPONENT OUT
LAN LAN
WIRELESS LAN AUX IN AUX IN
VIDEO OUT VIDEO OUT
5V 350mA
Wireless LAN Adapter
(not supplied)
2011-12-23 2011-12-23 3:58:54 3:58:54